Page 1 of 1
60% mount speed not going 60% speed
Posted: Sun May 01, 2022 10:33 pm
by Solex0627
Kalvyn mount has not been going the set speed of 60%
https://youtu.be/9HdDCbimmas
Re: 60% mount speed not going 60% speed
Posted: Sun May 01, 2022 10:35 pm
by Solex0627
Also found this had spawned mounted up and started going then got stuck was not able to get un stuck from here with out useing the unstuck command
https://youtu.be/ASCHQNcq0HA
Re: 60% mount speed not going 60% speed
Posted: Sun May 01, 2022 10:39 pm
by Omegus
Not sure why these are here instead of on the bug tracker.
Regarding the mounts: if the person on /follow is using the 64-bit client without capping the frame rate in their drivers (32-bit client is already capped), then at high frame rates animations and movement speed breakdown on the client. Tell the person on /follow to use the 32-bit client (or cap the frame-rate at 90-100) and try the test again.
Re: 60% mount speed not going 60% speed
Posted: Tue May 03, 2022 6:07 pm
by joneees
Visually mounts move at 50% speed and after some time warp to their correct location. So if you did this test for longer than a few seconds you would see the yo-yo effect on guard range as he would warp closer to you and you would gap him again and so on, but there's gonna be a small gap as he is following you at 50% speed until you warp to your correct location for the first time.